1. <strike id="tnfk5"><address id="tnfk5"><td id="tnfk5"></td></address></strike>

          1. <table id="tnfk5"></table>

            Hello, welcome to visit Dongguan huada machinery co. LTD site!

            About Us | Contact Us | Feedback | Site Map

            About Us

             

            Contact: Mr. Zhou (Business Manager)

            Tel: 0769-83350969

            Phone: 13829119477

            Fax:86 0769 85623822

            Address: a district rhinoceros Pei Yuen Kong Road, Dalang Town, Dongguan City, Guangdong, China Wu Xiang 56

            Post Code: 523100

            Main Products

            News

            You are here:Home > News

            Blender is a large plastic injection molding production of Big Brother

            Time:2014-1-22 Click:4018

            Large plastic mixers and mixing all kinds of agitation of granular materials and masterbatches , this machine is a large plastic mixing equipment , which overcomes the deficiencies of traditional blender hold a variety of mixed side, plastic extrusion , injection molding production ideal equipment.
            1 . Drums and even stainless steel spiral leaf , Du rust -colored , easy to clean.
            2 . Frame by frame design with rugged .
            3 . After processing the whole propeller welding, high concentricity , smooth operation.
            4 . Vertical operation , covering note .
            5. Sealed stir ; mixing uniformity , no leakage of material .
            6. Horsepower , mixing big , fast , 3 - 5 minutes immediately be uniform.
            7 . Rack chassis design grease filling device , bearing durability .
            8. Optional devices attached (1 electric devices, two propellers turning protected. ) Can be widely used : plastic pellet , regrind , plastic film material, plastic materials and add masterbatch stir old homogenization purposes. Application sectors ; pipe profiles, plastic materials, plastic granulator , masterbatch manufacturing, renewable materials recycling and processing , large injection molding industry .
            Large plastic mixer failure problems :
            1 when the stirring shaft is not long , the length of time of less than 1 m , the bearing arrangement can be canceled , it can effectively prevent the bearing lubricating fluid into the mixing tank , the tank material contamination problem . Below this AAF vertical mixer is based Shanghai customers, " stirred tank materials require strict conditions to avoid the oil pollution ," the special needs of the pollution -free design.
            2, the bearing arrangement must be used , you can set the cap on the agitator shaft , combined with mixing tank superstructure set up a ledge retaining device can effectively prevent gear bearing seal leakage problems after long-term use of stirred tank fall .
            大型塑膠攪拌機

            Navigation

            more +

            Home | Company Profile | Products | Contact Us | Recruitment | Site Map | XML Map

            Copyright:Dongguan DaLingshan Huada Plastic Machinery Factory Contact:Mr.Zhou Phone:0769-83350969

            Tel:13829119477 Fax:0769-85623822 Address:Dalang Town, Dongguan City, Guangdong, China Wu Xiang rhino slope of a District 56
            Zip Code:523100 Technical support:Hangzhou Xisi

                1. <strike id="tnfk5"><address id="tnfk5"><td id="tnfk5"></td></address></strike>

                  1. <table id="tnfk5"></table>

                    无码一区二区三区亚洲人妻